ImportantSCS requires RHEL/CentOS 7 or RHEL/Rocky Linux 8 installed. |
SCS may be installed in either a VM or bare-metal environment. See Hardware Selection for hardware requirements.
CautionWhen running SCS within a virtual machine, care must be taken to restore proper network connectivity after restoring from a snapshot. After restoring from a snapshot, the following command should be run within the SCS VM to ensure SCS components have proper access to the network:
|
To verify the version of CentOS installed:
cat /etc/centos-release |
To verify the version of RHEL installed:
cat /etc/redhat-release |
Following is the set of requirements for partitioning specific to the OS capacity.
Device | Mount | Partition Type | File System Type | Size | Options |
/dev/sda1 | /boot | GPT | xfs | 10 GiB | Bootable |
/dev/sda2 | / | GPT | xfs | 20 GiB | NA |
/dev/sda3 | /var/lib | GPT | xfs | 50 GiB | NA |
/dev/sda4 | /var/log | GPT | xfs | 30 GiB | NA |
/dev/sda5 | /var | GPT | xfs | >=40 GiB (expand to fill disk) | NA |
Once the operating system has been installed and the partitions configured, install the Swarm support tools.
InfoThese tools greatly assist the support process should assistance be required. Installing them is highly recommended! |
The table shown below contains information about the example site being set up:
Username | root | |
Password | datacore | |
Hostname | scs-lab1.datacore.internal | |
Application Network | IP Address | 172.16.33.10/24 |
Private Network | IP Address | 192.168.9.10/24 |
Private (Storage) Subnet | IP Address | 192.168.9.0/24 |
Network Gateway | 172.16.33.1 | |
NTP | 172.16.33.4,172.16.33.5 |
Next, SCS Installation. |