Page Comparison

Before new hardware can be managed by the Platform server, you need to power it on manually for the first and only time. This initial step enlists the machine with the Platform server, after which the hardware automatically powers itself off.  After enlistment, new hardware appears in the CLI with the state “New”, and it can remain in that state indefinitely until needed.

Note: Enlistment is non-destructive to existing data. If the machine was added by mistake to the subnet that Platform server manages and is enlisted, you can correct it. No installation happens until you use the CLI to deploy Swarm to the chassis.

Once new hardware is enlisted, Platform sees it as available for commissioning, which occurs when you run a CLI command that deploys the hardware and boots Swarm. The deployment command automatically pushes the new hardware through all of the required operations. After the deploy operation starts, you can use the “list nodes” CLI command to view the chassis moving through the different states.

Note: The first power on and commissioning steps are also non-destructive to any existing data on the disks. Any data on the disks persists until Swarm is booted on the second power on operation, after which the persistence of any existing data is determined by Swarm.